Prepping your equipment correctly is the foundational step to a proper Shrink Wrap installation. Taking these steps prior to shrinking your material will help to ensure a packaging system to exceed your transport and storage needs.

Plan ahead before ordering supplies. When shrink wrapping large items and equipment, you essentially follow the same steps as shrink wrapping a boat. A key element is knowing the difference of wrapping for transport or wrapping for storage. When  wrapping for transport it is crucial to have zero air-flow getting into your wrapped area. You want a complete seal so air/ wind cannot enter and balloon-out the wrap job. For storage you may want to use vents, desiccant bags or other anti-moisture products to prevent moisture build up within the wrapped enclosure. You can also apply Transport Tape to protect painted metal, sensitive graphics and plastic surfaces during transport. You will also need the correct accessories to complete the job. Deciding if you want to 100% wrap the equipment, or use a hard attachment with tape and/ or strapping will determine your supplies needed. A minimum list of supplies may include: Propane fired heat gun, 7 or 8 mil roll of material, Heat Shrink Tape (and/ or strapping) for attachment  & spray adhesive for heat seaming. If you are concerned with corrosion and rust within your shrink wrapped equipment, you can add anti-rust VCI Capsules that are designed to fight against airborne corrosion.

Choosing the correct roll size. When measuring your equipment you want to get the highest and widest point to determine which roll size will be the best for your project and upcoming projects. If you have multiple projects, you want to choose the best width roll that will cover the dimensions for all objects being wrapped. The material will be draped over equipment, and depending on attachment method, you may want to measure out an extra foot.  A 7 mil is perfect for storage and/ or transport. It is formulated with a 1 year UVI for Ultra-Violet Resistance. If you are wanting a heavier thickness, the 8mil is also a good choice for transport and storage jobs.

Padding off sharp edges and delicate areas. You can use poly foam padding and/ or any scrap plastic or fabric you may have laying around. Walk around perimeter of equipment and pad off any protruding areas that may need cushioning to prevent tears in the plastic. -A fully-sealed area makes for the best packaging system. Also, pad off any sensitive areas for extra protection. Make sure the equipment you are wrapping is clean and completely dry inside and out.

Draping the Shrink Wrap & Eliminating Heavy Concentrated Overlaps. On wrap site, open the film at center fold and carefully drape the pre-cut film over equipment. Try to prevent dirt and debris coming in contact with shrink wrap. Equally trim off excess film around perimeter. Cut out heavy overlaps of the plastic to prevent concentrated Shrink Wrap bunches.

Preparation = Success !

Preparation = Success !

You are now prepared to proceed to the Shrink Wrapping Process!